Automatic Technology Australia Elite Installationshandbuch PDF herunterladen (Seite 9)

INSTALLING DRIVE UNIT ARMS

FIG. 5

AFFIXING ARMS AND BRACKETS TO GATE

1. Position gate in close position.

2. Attach drive arm extension to drive arm (fixed to the drive

unit) (Fig. 1), using two (2) Hex. Head screws and spring and

flat washers supplied.

3. Attach slave arm to drive arm extension using plastic

washers and shoulder screw supplied. (see Page 6).

4. Assemble Gate Mounting Bracket and Slave Arm using

shoulder screw and plastic washers, do not tighten yet.

5. Extend arms out straight and mark position where the Gate

Mounting Bracket touches gate (Fig. 5).

6. From this mark, measure 10mm toward Drive Unit and mark

again. This is where Gate Mounting Bracket will be mounted.

7. Remove the Gate Mounting Bracket from the Slave Arm and

secure the Gate Mounting Bracket to the gate at second mark.

8. Reassemble Slave Arm to Gate Mounting Bracket using

shoulder screw and plastic washers. Secure firmly.

INSTALLING MINIMUM SIDE ROOM KIT

If you have limited side room, an optional drive arm modification

kit reduces the gate opener’s required side room to the width of the

drive unit (135mm). (ATA Order code 90182).

FITTING MINIMUM SIDE ROOM KIT

1. Secure the extension arm from the minimum side room kit onto

drive arm extension with supplied M12 screws. Drill Ø12 hole

in Drive Arm Extension (use hole in extension arm as a guide).

Insert other M12 screw and secure with spring washer and nut.

Check that screws are tight (Fig. 7).

2. Check that Drive Unit is DISENGAGED AND GATE IS

CLOSED. Slide the Guide Track over idler. Locate Track on

gate and check travel of the Arm. The idler should always be

inside the Guide Track in the closed and open positions. Secure

track to gate (weld if possible).

NOTE: If a shorter arm is required, drill the drive arm extension

and extension arm where appropriate, you should not have to cut

the arms and should still be able to use pre-threaded hole in drive

arm extension.

FIG. 6

FIG. 7

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Keine Kommentare

Automatic Technology Australia Elite Installationshandbuch Seite 9